A.A CSU/DSU terminates a digital local loop
B.A modem terminates a digital local loop
C.A CSU/DSU terminates an analog local loop
D.A modem terminates an analog local loop
E.A router is commonly considered a DTE device
F.A router is commonly considered a DCE device

A.application layer
B.session layer
C.transport layer
D.network layer
E.datalink layer
F.physical layer

A.192.168.10.80/28
B.192.168.10.80/29
C.192.168.10.96/28
D.192.168.10.96/29

A.Configure port Fa0/1 to accept connections only from the static IP address of the server.
B.Employ a proprietary connector type on Fa0/1 that is incompatible with other host connectors.
C.Configure the MAC address of the server as a static entry associated with port Fa0/1.
D.Bind the IP address of the server to its MAC address on the switch to prevent other hosts from spoofing the server IP address.
E.Configure port security on Fa0/1 to reject traffic with a source MAC address other than that of the server.
F.Configure an access list on the switch to deny server traffic from entering any port other than Fa0/1.

A.The router will use the static route.
B.The router will use the OSPF route.
C.The router will use the EIGRP route.
D.The router will load balance and use all three routes.

A.you can apply multiple access lists with the same protocol or in different…
B.you can config one access list,per direction,per layer 3 protocol
C.you can placeasmanyaccess lists as you want on any interface
D.you can apply ony one access list on any interface

A.neighbor table
B.SPF table
C.RTP table
D.topology table
E.query table
F.DUAL table

A.packet switching
B.access layer security
C.path selection
D.VLAN membership assignment
E.bridging between LAN segments
F.microsegmentation of broadcast domains

A.It is locally significant.
B.It is globally significant.
C.It is needed to identify a unique instance of an OSPF database.
D.It is an optional parameter required only if multiple OSPF processes are running on the router.
E.All routers in the same OSPF area must have the same process ID if they are to exchange routing information.

A.Each end of the trunk line must be set to IEEE 802.1E encapsulation.
B.The VTP management domain name of both switches must be set the same.
C.All ports on both the switches must be set as access ports.
D.One of the two switches must be configured as a VTP server.
E.A rollover cable is required to connect the two switches together.
F.A router must be used to forward VTP traffic between VLANs.