A.The default route should have a next hop address of 64.100.0.3.
B.Hosts on the LAN that is connected to FastEthernet 0/1 are using public IP addressing.
C.The address of the subnet segment with the WWW server will support seven more servers.
D.The addressing scheme allows users on the Internet to access the WWW server.
E.Hosts on the LAN that is connected to FastEthernet 0/1 will not be able to access the Internet without address translation.

A.to verify the type of cable interconnecting two devices
B.to determine the status of network services on a remote device
C.to obtain VLAN information from directly connected switches
D.to verify Layer 2 connectivity between two devices when Layer 3 fails
E.to obtain the IP address of a connected device in order to telnet to the device
F.to determine the status of the routing protocols between directly connected routers

A.RAM
B.NVRAM
C.flash memory
D.HTTP server
E.TFTP server
F.Telnet server

A.A switch in the VTP client mode cannot update its local VLAN database.
B.A trunk link must be configured between the switches to forward VTP updates.
C.A switch in the VTP server mode can update a switch in the VTP transparent mode.
D.A switch in the VTP transparent mode will forward updates that it receives to other switches.
E.A switch in the VTP server mode only updates switches in the VTP client mode that have a higher VTP revision number.
F.A switch in the VTP server mode will update switches in the VTP client mode regardless of the configured VTP domain membership.

A.訪問控制列表
B.加密路由器密碼
C.生成樹
D.虛擬局域網
E.VTP
F.無線局域網

A.the amount of available ROM
B.the amount of available flash and RAM memory
C.the version of the bootstrap software present on the router
D.show version
E.show processes
F.show running-config

A.是一個本地的標識
B.是一個全局的標識.
C.為了標識OSPF數據庫中的唯一的實例
D.是一個可選的參數，只有多個OSPF進程在同一個路由器上運行時才需要
E.所有在同一個OSPF區域的路由器必須用同一個進程號，否則它們無法交換路由信息。

A.Administratively shut down the interface.
B.Physically secure the interface.
C.Create an access list and apply it to the virtual terminal interfaces with the access-group command.
D.Configure a virtual terminal password and login process.
E.Enter an access list and apply it to the virtual terminal interfaces using the access-class command.

A.10Mbps
B.11Mbps
C.54Mbps
D.100Mbps

A.所有的路由器會參照自己的拓撲數據庫，看它們是否有到192.168.1.0的備份路由。
B.R2和R3會標記到192.168.1.0的路由為不可用，并且不會從R1接受更新直到它們的抑制定時器超時
C.由于水平分割原則，R2不會向R1發送關于去往192.168.1.0網段的錯誤信息
D.當R2從R1那里學到192.168.1.0網段不可達時，R2把去往192.168.1.0網段的度量值設置為無限大，并向R1發送回應消息。
E.R1將會發送LSA給R2和R3通知它們網絡的變化情況，然后所有的路由器周期性的遞增的發送更新直到網絡收斂。