A.enable cdp
B.cdp enable
C.cdp run
D.run cdp
您可能感興趣的試卷
你可能感興趣的試題
A.data integrity
B.encryption
C.key exchange
D.authentication
A.ip default-gateway 0.0.0.0
B.ip route 172.16.2.1 0.0.0.0 0.0.0.0
C.ip default-network 0.0.0.0
D.ip default-route 0.0.0.0 0.0.0.0 172.16.2.1
E.ip route 0.0.0.0 0.0.0.0 172.16.2.1
A.point-to-point
B.broadcast multi-access
C.nonbroadcast multi-access
D.nonbroadcast multipoint
E.broadcast point-to-multipoint
A.NVRAM
B.RAM
C.FLASH
D.ROM
E.PCMCIA
A.copy running-config: TFTP
B.copy TFTP: running-config
C.copy TFTP: startup-config
D.copy startup-config: TFTP
A.SW1#shows withport port-security interface FastEthernet0/12
B.SW1#shows withport port-secure interface FastEthernet0/12
C.SW1#show port-secure interface FastEthernet0/12
D.SW1#show running-config
A.允許125.36.0.0/16網段的主機使用FTP協議訪問主機129.1.1.1;
B.不讓任何主機使用Telnet登錄;
C.拒絕一切數據包通過;
D.僅允許某個用戶從外部登錄,其他用戶不能這樣做。
A.to control vty access into a router
B.to control broadcast traffic through a router
C.to filter traffic as it passes through a router
D.to filter traffic that originates from the router
E.to replace passwords as a line of defense against security incursions
A.copy running-config startup-config
B.copy startup-config: running-config
C.copy running config startup config
D.copy startup config running config
E.write terminal
最新試題
請參見圖示。在網絡中,PC1向PC2發送了一條消息。PC2收到的幀如圖所示。該幀中的哪一信息確定了正確的目的應用程序?()
PC 無法連接到任何遠程網站,無法ping 通其默認網關,也無法ping 通本地網段中工作正常的打印機。以下哪項操作可以確認此PC 上的TCP/IP 協議棧是否工作正常?()
請參見圖示。主機B 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,San Francisco 器由器的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為10.10.1.2而目的IP 地址為10.31.1.20的數據包。捕獲該幀時,它的目的MAC 地址是什么?()
請參見圖示。已啟用路由器的NAT 功能供PC 訪問Internet??梢詾槁酚善鹘涌赟0/0/0分配下列哪一個IP 地址?()
請參見圖示。主機A 正在訪問多臺服務器。結合使用什么端口號和地址即可唯一識別特定服務器上運行的特定進程?()
請參見圖示。下列哪組設備僅包含中間設備?()
要將數據包發送到遠程網絡,應使用哪種設備?()
請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接?()
請參見圖示。網絡技術人員使用圖中所示的連接將主機A 連接到路由器以創建初始配置。下列有關此連接的陳述中哪一項正確?()
何時必須使用clock rate 命令配置路由器串行接口?()